jcwgp.com

GoMINIGo Third Brake Pulsar

March 10, 2007 on 11:20 am | In Recent Posts |

Today,  I installed the GoMINIGo Third Brake Light Pulsar on GP0154 which flashes the third brake light four times in 1.5 seconds after the brake is applied and then the brake light will remain on without flashing as long as the brake is depressed.  Releasing the brakes and reapply the brakes will pulse again.   Hopefully it will help keep everyone off of little GP’s rear.   Click here for the Light Pulsar in Action 

Removed the three screws holding the third brake light onto the hatch and followed the Cabrio instructions as the GP has the black (+)/brown (-) wires usually found in the Cabrio then the black/red found in the S.    

Make sure you follow Step 3 carefully.   The black/yellow strip wire is the positive + and the brown is the negative -.   With the writing on the pulsar towards you, so you can read the name, connect the wires from the car harness to the right side and the light connector wires to the left.